[cpia] ezonics
George Talusan
gstalusan@math.uwaterloo.ca
Wed, 12 Apr 2000 19:32:51 EDT
Hi folks,
I'm running 2.3.99-pre4 and after using gqcam-0.7.2 for a few
minutes the driver hangs. gqcam goes into D state and the
only way to get CPiA working again is by rebooting.
I'm using an Abit BP6 2x466MHz, and an EZonics EZcam USB.
Could this be a USB or CPiA problem?
Here's dmesg.
cpia data error: [9] len=768, status=FFFFFFAC
cpia.c:parse_picture(1960):line length was not 1 but -2 after 3806/19886
bytes
cpia data error: [7] len=288, status=FFFFFFAC
cpia.c:parse_picture(1960):line length was not 1 but 0 after 18483/20836
bytes
cpia data error: [6] len=128, status=FFFFFFAC
cpia data error: [7] len=320, status=FFFFFFAC
cpia data error: [8] len=128, status=FFFFFFAC
cpia data error: [9] len=96, status=FFFFFFAC
cpia.c:parse_picture(1960):line length was not 1 but -1 after 14574/18075
bytes
usb-uhci.c: interrupt, status 2, frame# 1071
cpia data error: [0] len=416, status=FFFFFFAC
cpia data error: [5] len=256, status=FFFFFFAC
cpia.c:parse_picture(1960):line length was not 1 but -2 after 12901/25178
bytes
usb-uhci.c: interrupt, status 2, frame# 1449
usb-uhci.c: interrupt, status 2, frame# 661
usb-uhci.c: interrupt, status 2, frame# 1575
usb-uhci.c: interrupt, status 2, frame# 295
usb-uhci.c: interrupt, status 2, frame# 1541
usb-uhci.c: interrupt, status 2, frame# 1673
george