[cpia] Fatal error

[Samo Gabrovec]

The problem was in the cable. it was cut at the entrance to the camera.
there are 9 wires and only one was cut.... i found that thanks`s to you
peter now tha cam works again.
Thank you thank you!



----------------------------------------------------------------
Its a JOKE, like the funny kind but different.
----------------------------------------------------------------
Visit http://www.velenje.cx
----------------------------------------------------------------
On Wed, 19 Apr 2000, Peter Pregler wrote:

> On Tue, Apr 18, 2000 at 09:50:42PM +0200, Samo Gabrovec wrote:
> > 1. I would like to tell that i had a working setup with webcam II for at
> > least 2 months. I didn`t change anything except i rebooted.
> > Is my camera broken?
> > the modules load like they should but when i try to run a program like
> > gqcam it says: /dev/video: Input/output error
> > and in the logs i get :cpia.c(18780):reset_camera(2475):fatal_error:
> > 0x20
> > what is this fatal error?
> 
> IIRC this means that the VP cannot be powered on. In case of a parport
> camera this usually happens if the camera is connected to the parallel
> port but not to the keyboad (i.e. no power).
> 
> -Peter
> 
> -- 
> Email: Peter.Pregler@risc.uni-linz.ac.at
> WWW:   http://www.risc.uni-linz.ac.at/people/ppregler
> 
> _______________________________________________
> cpia mailing list  -  cpia@risc.uni-linz.ac.at
> http://mailman.risc.uni-linz.ac.at/mailman/cgi-bin/listinfo/cpia
>