[cpia] Microtek Eyestar 2 not working

[Edd Dumbill]

I seem to be having the same difficulties as mentioned in this mail:
http://mailman.risc.uni-linz.ac.at/pipermail/cpia/2000-April/000667.html

I include the output from dmesg below. I'm using IRQ 7, DMA 3 parport at
0x378.  I'm using kernel version 2.2.13, Debian potato.

Although it tells me that one camera is detected, it doesn't actually
work. Trying to invoke gqcam gives '/dev/video: No such device' even
though I've done the mknod etc. as specified in the gqcam INSTALL file.

Any help would be much appreciated.
thanks

-- Edd Dumbill

----output from dmesg------

Parallel port driver for Vision CPiA based cameras v1.0.0
  using DMA mode (irq 7, DMA 3)
cpia_pp.c(49646):Negotiate2SetupPhase(362):Busy should be high at
beginning
cpia_pp.c(49679):my_wait_peripheral(327):failed 0x58 should be 0xd0
waited 33 jiffies
cpia_pp.c(49679):Valid1284Termination(514):status bit did not go to the
correct value
cpia_pp.c(49679):Negotiate2SetupPhase(362):Busy should be high at
beginning
cpia_pp.c(49712):my_wait_peripheral(327):failed 0x58 should be 0xd0
waited 33 jiffies
cpia_pp.c(49712):Valid1284Termination(514):status bit did not go to the
correct value
cpia_pp.c(49712):Negotiate2SetupPhase(362):Busy should be high at
beginning
cpia_pp.c(49745):my_wait_peripheral(327):failed 0x40 should be 0x0
waited 33 jiffies
cpia_pp.c(49745):SimECPReadBuffer(540):nAck didn't went down after read
1 bytes no more data ?
cpia_pp.c(49778):my_wait_peripheral(327):failed 0x58 should be 0xd0
waited 33 jiffies
cpia_pp.c(49778):Valid1284Termination(514):status bit did not go to the
correct value
cpia.c(49778):do_command(1730):c003 - failed, retval=-5
  1 camera(s) found